Table of Contents
Advertisement
Caller ID/Talking Caller ID
Problem
Caller information is not
displayed.
Caller information is
displayed or announced
late.
Caller's phone number is
not announced.
Time on the unit has
shifted.
The name stored in the
phonebook is not fully
displayed while an outside
call is being received.
Liquid damage
Problem
Liquid or other form of
moisture has entered the
handset/base unit.
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
TGE610HK(en_en)_0817_ver030.pdf 39
Cause/solution
R You must subscribe to a Caller ID service. Contact your phone
service provider for details.
R If your unit is connected to any additional telephone
equipment, remove and plug the unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend connecting a
DSL/ADSL filter between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for details.
R Other telephone equipment may be interfering with this unit.
Disconnect the other equipment and try again.
R Depending on your phone service provider, the unit may
display or announce the caller's information at the 2nd ring or
later. Set the first ring to "Off" (page 24).
R Move closer to the base unit.
R The handset's ringer volume is turned off. Adjust it (page 14,
24).
R The Talking Caller ID feature is turned off. Turn it on (page 24).
R Incorrect time information from incoming Caller ID changes the
time. Set the time adjustment to "Manual" (off) (page 24).
R Edit the phonebook entry name to fit in 1 line of text (page 20).
Cause/solution
R Disconnect the AC adaptor and telephone line cord from the
base unit. Remove the batteries from the handset and leave to
dry for at least 3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and telephone line
cord. Insert the batteries and charge fully before use. If the unit
does not work properly, contact an authorised service centre.
Useful Information
39
2018/08/24 8:12:11
Advertisement
Table of Contents
