Advertisement
Performing Manual Drain
In the event the washer will not drain under its own power due
to a power outage or clogged drain pump you can drain the
water left in the drum manually.
CAUTION
BURN HAZARD
Do not attempt to manually drain the drum if it is full of hot
water. Allow water to cool before proceeding with manual
draining.
In the event the washer will not drain under its own power due
to a power outage or clogged drain pump you can drain the
water left in the drum manually.
1. Remove pump cleanout door.
2. Place a catch pan underneath the drain pump filter to
collect water as it drains.
3. Without removing the pump filter, rotate the filter 180°
counterclockwise to allow the water to flow out into the
catch pan. It may be necessary to close the filter and
drain the catch pan as it fills.
4. Repeat the process until all the water has been drained.
NOTE
Always keep a rag nearby to clean any water spills.
Cleaning Pump Filter
With the wash tub and drain hose drained of all water and
the drain spout snapped in place, follow these directions to
remove, clean, and reinsert the pump filter.
1. "Unscrew" the filter and pull it out.
2. Dump the filter and inspect the opening for any loose
objects.
3. Rinse the filter completely before putting it back in place.
IMPORTANT
Check to make sure O-ring is in place before reinserting
pump filter. Take care to not cross threads when turning
pump filter during reinsertion.
4. "Screw" filter back in place until it stops. DO NOT
overtighten.
5. Reinstall pump cleanout door if removed earlier.
NOTE
You may have to add about 2 litres of clean water through the
mainwash detergent compartment to reprime the drain pump.
Care and Cleaning
1
180°
1
1
19
2
2
2
Advertisement
