Table of Contents
Advertisement
Section 3 - Configuration
My IPv6 Connection:
Select PPPoE from the drop-down menu.
PPPoE:
Enter the PPPoE account settings supplied by your Internet
provider (ISP).
Address Mode:
Select Static if your ISP assigned you an IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in the
next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnection Mode:
Select either Always-on, On-Demand, or Manual.
Maximum Idle Time:
Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable
Auto-reconnect.
MTU:
Maximum Transmission Unit - you may need to change the MTU
for optimal performance with your specific ISP.
IPv6 DNS Settings:
Select either Obtain DNS server address automatically or Use
the following DNS Address.
Primary/Secondary DNS
Enter the primary and secondary DNS server addresses.
Address:
LAN IPv6 Address:
Enter the LAN (local) IPv6 address for the router.
LAN Link-Local Address:
Displays the Router's LAN Link-Local Address.
Enable Autoconfiguration:
Check to enable the Autoconfiguration feature.
D-Link DIR-862L User Manual
PPPoE
74
Advertisement
Table of Contents
