Specifications; Battery Replacement - Greenlee CM-600 Instruction Manual

Specifications

Display: 3-1/2-digit LCD (1999 maximum reading)
Sampling Rate: 4 per second
Low Battery Indication:
Jaw Opening: 35 mm (1.38")
Maximum Conductor Diameter: 33 mm (1.30")
Overvoltage Category: Category III, 600 V
Temperature Coefficient: 0.2 x (specified accuracy) per C below 18 C or above 28 C
Operating Conditions: 0 C to 45 C (32 F to 113 F), 0% to 75% relative humidity
Storage Conditions: -20 C to 60 C (-4 F to 140 F), 0% to 80% relative humidity
Remove battery
Altitude: 2000 m (6500') maximum
Pollution Degree: 2
Battery: 9-Volt battery (NEDA 1604, JIS 006P or IEC 6LF22)

Battery Replacement

Before opening the case, remove the test leads (or jaw) from the circuit and shut off
the unit.
Failure to observe this warning can result in severe injury or death.
1. Disconnect the unit from the circuit. Turn the unit OFF.
2. Remove the battery cover screw.
3. Remove the battery cover.
4. Replace the battery (observe polarity).
5. Replace the cover and screws.
Cleaning
Periodically wipe the case with a damp cloth and mild detergent; do not use abrasives
or solvents.
CM-600 • CM-650
11