Table of Contents
Advertisement
CONVERSION TO LP GAS
1) Remove grates, burner caps and burner heads.
2) Remove the brass orifice spud in the chimney of
each burner using a 13/32" or 10 mm nut driver.
3) Install the LP orifice spuds into their correct
positions as described previously.
4) To prevent leakage, make sure the orifice spuds
are securely screwed into the gas supply tubes.
5) For the right front burner, the choke and self
threading screw will be needed as shown in
Fig.1.
Insert the choke into the burner base, then insert
the set screw into the burner base and tighten
securely. Make sure the screw head is against
the shoulder (within choke notch), so it does not
have any rotational movement.
Set Screw
Burner base
Fig.1
6) Put the old orifice spuds into conversion kits and
place back on the range for possible future
conversion.
NOTE : If an orifice spud is accidentally dropped,
the cooktop can be raised as follows:
1) Remove vent trim rear cover, rear cover, vent trim
and vent cover.
2) Using a Phillips head screwdriver remove the 2
side and 2 front screws of the cooktop.
(On some model : Remove the only 2 front screws
of the cooktop)
3) Remove (11EA) hex-Phillips head screws on the
cooktop and lift it.
Burner cap
Choke
When reinstalling
the cooktop be
sure to align the
electrodes with
the openings in
the cooktop.
6. CONVERT THE OVEN BURNER ORIFICES
OVEN REAR BURNER(BAKE)
Rotate the orifice spud counterclockwise to remove.
1) Remove vent trim rear cover and rear cover.
Then remove the nozzle holder using 13/32" or
10mm wrench and Phillips head screwdriver.
2) Remove the orifice spud from nozzle holder
using a 13/32" or 10 mm nut driver.
3) Install the LP orifice spud(Y) to the nozzle holder.
To prevent leakage, make sure the orifice spud is
securely screwed into the nozzle holder.
BROIL BURNER
HOT SURFACE
WIRE COVER ORIFICE
IGNITER
BROIL BURNER
ASSEMBLY
1) Remove oven door and broil burner assembly.
Then remove the wire cover using a Phillips
head screwdriver.
2) Release the connector of the igniter.
3) Remove the orifice spud from nozzle holder
using a 13/32" or 10mm wrench.
4) Install the LP orifce spud(F) to the nozzle holder.
To prevent leakage, make sure the orifice spud is
securely screwed into the nozzle holder.
5-3
VENT TRIM
REAR COVER
REAR COVER
NOZZLE HOLDER
ORIFFICE
(NOZZLE)
(NOZZLE)
NOZZLE
HOLDER
Rotate the orifice spud
counterclockwise to
remove.
Advertisement
Table of Contents
