Advertisement
Before you call for service...
Troubleshooting Tips
Problem
Excessive smoking
Oven door will not open
after a clean cycle
Oven not clean after
a clean cycle
Oven door will not
unlock (on models
with a door latch)
"Door" appears in the
display (on models
with a door latch)
"F—and a number or
letter" flash in the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
46
Possible Causes
Excessive soil.
Oven too hot.
Oven controls not properly set.
Oven was heavily soiled.
Oven is too hot.
Self-cleaning cycle has been
selected but the latch handle
was not moved all the way
to the right.
Latch handle was moved to the
right but a program other than
self-cleaning was selected.
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
You have a function error code.
If the function code repeats.
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is turned off so that it
does not show in the display.
Power failure.
Oven control pads were
not touched properly.
What To Do
• Touch the CLEAR/OFF pad. Open the windows to rid
the room of smoke. Wait until the light on the SELF
CLEAN pad goes off. Wipe up the excess soil and reset
the clean cycle.
• Allow the oven to cool below locking temperature.
• See the Using the self-cleaning oven section.
• Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
• Allow the oven to cool below locking temperature.
Do not lock the door with the door latch except when
using the self-clean feature.
• Move the latch handle all the way to the right.
• Move the latch handle to the right only when setting
the self-cleaning cycle.
• The latch may have been moved, even if only slightly,
from the locked position. Make sure the latch is moved
to the right as far as it will go.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Using the clock and timer section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 3 seconds.
Advertisement
