Intex KOM0037 User Manual page 8

Owner's manual
PRESENTATION
The UPS is a standby Uninterruptible Power System (UPS). When utility input is nor-
mal, the UPS would provide surge protection and energy to charge the internal battery.
If the utility input is abnormal, the UPS can supply AC power to the load immediately.
(1). Utilizes microprocessor based controls; it will minimizes the dependency on hard-
ware.
Beside this, it maximizes system's flexibility and optimizes the assurance of reliability.
(2). Automatic frequency selection to mate with utility power.
(3). High level battery charger to prolong battery's life and fully charge the battery.
(4). With actually overload protection both in line and battery mode.
INSTALLATION & OPERATION
• Inspect the UPS upon receipt. The package is recyclable; save it for reuse or dispose
of it properly.
• The input power cord on the rear panel needs to plug into a socket on the wall.
Please notice the voltage of utility power should match with the UPS.
• The employed equipment's power cords (such as computer) are plugged into the
sockets on the rear panel.
• While utility input in connected to the UPS, press the power switch for 3 seconds.
After that, connect the electrical cords of the equipment that is going to be used such
as computer or monitor with the terminal on the rear panel of UPS.
Attentton: PC and monitor can be connected with the UPS output for protection. The
max total power consuming should be less than its max rating.
Attentton: Push down the UPS' 'Power' button, the normal 'green led' will turn in for
normal commercial input power.
Attentton: If UPS has not been used for 3 months of the period. The first time turn-
EN
ing on UPS have to be connected with commercial input power for at least 6 hours of
recharging the battery to ensure the battery life and performance.
Attentton: This particular model of UPS can not be connected with external battery
pack for longer battery back up time.
Attentton: If there is RS232 connector on the rear panel, please see the enclosed CD
for the instruction of how to install and how to use . Be noted that if there's not RS232
connector on the rear panel, there isn't any CD enclosed.
• Press the power switch for 3 seconds to turn off the UPS.
8