Advertisement
Quick Links
Advertisement
Related Manuals for Hotpoint Active Care NM11945GCAUKN
Summary of Contents for Hotpoint Active Care NM11945GCAUKN
- Page 1 User Manual www.hotpoint.eu/register...
- Page 2 Quick Guide THANK YOU FOR PURCHASING A HOTPOINT PRODUCT Before using the appliance carefully read the Health and Safety guide. To receive more comprehensive assistance, register the Before using the machine, it is imperative that the transport bolts are removed. For more appliance on detailed instructions on how to remove them, see the Installation Guide.
- Page 3 WASH CYCLES Follow the instructions on the symbols of the garment’s wash DEMO care label. The value indicated in the symbol is the maximum recommended temperature for washing the garment. Mixed For washing lightly to normally soiled resilient garments in cotton, linen, synthetic fibres and mixed fibres.
- Page 4 PAUSING A CYCLE For optimal maintenance we suggest using WPRO Limescale and grease remover, according to the instructions shown on the package. To pause the wash cycle, press the START/PAUSE button again. To start The product can be purchased by contacting the technical assistance service the wash cycle from the point at which it was interrupted, press the or through the website www.whirlpool.eu.
- Page 5 TROUBLESHOOTING Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service, make sure that the problem cannot be easily solved using the following list. Anomalies Possible causes / Solution The appliance is not plugged into the socket fully, or not enough to make contact. The washing machine does not start.
-
Page 6: Cleaning And Maintenance
CLEANING & MAINTENANCE For any cleaning and maintenance, switch off and unplug the washing machine. Do not use flammable fluids to clean the washing machine. CLEANING THE OUTSIDE OF THE WASHING MACHINE Do not use glass or general purpose cleaners, scouring Use a soft damp cloth to clean the outer parts of the washing powder or similar to clean the control panel –... - Page 7 CLEANING THE DETERGENT DISPENSER Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used a hot wash programme, wait until the water has cooled down before draining any water.
-
Page 8: Transport And Handling
OCCURS, GET IN TOUCH WITH THE NEAREST rating plate). AFTER-SALES SERVICE To receive assistance, call the number shown on the warranty booklet or follow the instructions on the website www.hotpoint.eu When contacting our Client After sales service, always specify: • your full address; •... - Page 9 10 mm - 0,39 inch 150 ml 100 ml 50 ml 2 cm - 0,7 inch...
- Page 10 max 0,5 cm max 0,2 inch max 100 cm 39 inch max 100 cm min 65 cm 39 inch 25 inch min 65 cm 25 inch max 100 cm 39 inch min 65 cm 25 inch...
-
Page 11: Safety Instructions
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVE replace any part of the appliance unless Before using the appliance, read these safety instruc- specifically stated in the user manual. Keep tions. Keep them nearby for future reference. These instructions and the appliance itself provide impor- children away from the installation site. - Page 12 ELECTRICAL WARNINGS CLEANING AND MAINTENANCE It must be possible to disconnect the appliance WARNING: Ensure that the appliance is switched from the power supply by unplugging it if plug is off and disconnected from the power supply accessible, or by a multi-pole switch installed before performing any maintenance operation;...