Raymarine T70152 Installation Instructions Manual page 11

3 or 6 spokes
Note: The wheel drive is designed to work with 3 spoke clamps on
4 or 8 spoke wheels. For cosmetic reasons, however, you may want to
fit an extra spoke clamp to the fourth spoke. Raymarine dealers can
supply an extra spoke clamp (part number A18089).
3. Drill the appropriate spoke clamp holes using the larger of the
supplied drill bits (6.0 mm or
•
•
Note: The spoke clamps will cover these exit holes, so they will not be
visible when the wheel drive is installed.
Top 2 spoke clamp holes
are pre-drilled
drill from the inside, placing a piece of scrap wood under the
cover to produce a clean exit hole
you will need to drill 4 new holes so the cover has 6 holes in
total (2 for each spoke clamp)
1
/ in):
4
Piece of scrap wood
9
4 or 8 spokes
D5348-1b
D5347-1