Daily Use - Frigidaire FDC8203P User Manual

Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you close the
door, the laundry does not get
caught between the appliance door
and the rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options
for the type of load.
The display shows the programme
duration.
The drying time you see is related to
the load of 5 kg for cotton and jeans
programmes. For the other
programmes the drying time is related
to the recommended loads. If 5kg is
exceeded, the drying time of the cotton
and jeans programmes will be longer.
4. Press the Start/Pause touch button.
The programme starts.
Starting the programme with
delay start
1. Set the correct programme and options
for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
You can delay the start of a
programme from a minimum of 60
minutes to a maximum of 20 hours.
3. Press the Start/Pause touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates.
• The indicator
• The indicators
comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with the
crease guard phase for approximately other
30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicator
• The indicators
comes on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty the
water container when a programme is
completed.

DAILY USE

flashes.
Filter and Tank
is on but does not flash.
Filter and Tank
13