Fcc Information; Recommendation - Icom IC-400BB Instruction Manual

FCC INFORMATION

This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruc-
tion manual, may cause harmful interference to radio com-
munications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be re-
quired to correct the interference at his own expense.
CAUTION: Changes or modifications to this transponder,
not expressly approved by Icom Inc., could void your author-
ity to operate this transponder under FCC regulations.
NOTE: A WARNING STICKER is supplied with the USA
version transceiver. To comply with FCC regulations, this
sticker must be affixed in such a location as to be readily seen
from the operating controls of the radio. Make sure the chosen
location is clean and dry before applying the sticker.
v

RECOMMENDATION

CLEAN THE TRANSCEIVER AND MICROPHONE THOR-
OUGHLY WITH FRESH WATER after exposure to saltwater,
and dry it before operating. Otherwise, the transceiver's keys,
switches and controllers may become unusable, due to salt
crystallization.
NOTE: If the transceiver's waterproof protection appears defective,
carefully clean it with a soft, damp (fresh water) cloth, then, dry it
before operating.
The front panel may lose its waterproof protection if the case, jack
cap, or connector cover is cracked or broken, or the front panel has
been dropped. Contact your Icom distributor or your dealer for advice.