Door Swing - U-Line Outdoor Onb115 Quick Start Manual

QUICK START GUIDE
QUICK START GUIDE
FACTORY INSTALLED DRAIN PUMP
If your drain line will run up to a stand pipe, disposal or
spigot assembly, or does not otherwise meet the
requirements for a gravity drain, you may have ordered a
pre-installed U-Line P60 drain pump.
If you need to install a P60 drain pump into your unit, see
DRAIN PUMP section in the User Manual.
See below for typical installations requiring a drain pump.
Stand Pipe
P60 Pump Required
Disposal Assembly
P60 Pump Required
Air Gap
(Optional Hook-Up)
Waste
Valve
Cold
Water
Hot
Water
Waste
Waste
Cold
Water
Hot
Water
Valve
Y-Branch Tailpiece
P60 Pump Required
(Optional Hook-Up)
The maximum lift for the P60 drain pump is
10 feet. This must be done as close to the rear of
the unit as possible.

Door Swing

1/2" (13 mm) clearance is recommended from wall on
hinge side to allow the door to open 90°. Allow for
additional space for any knobs or pulls installed on the
integrated panel/frame.
Stainless Steel models that are installed adjacent to a wall
require 2-1/4" (57 mm) door clearance on hinge side to
allow for door handle.
Units have a zero clearance when installed adjacent to
cabinets.
1/2" (13 mm)
90°
Door Swing
Space Required
For any Knobs or Pulls
Integrated
9
13
Air Gap
Valve
Hot
Water
2-1/4" MIN
Wall
(57 mm MIN)
90°
Door Swing
Stainless
u-line.com
u-line.com
Waste
Cold
Water
Wall