Advertisement
3.2.3 ASSEMBLY/DISASSEMBLY OF [9] FRONT ASSY
CAUTIONS
(1) As the FRONT ASSY has complicated structure, do not
disassemble if not needed.
(2) After reassembling, check the smooth slide operation of
the two BARRIERS.
Disassembly procedure
(1) Remove the COVER (MIC).
(2) Remove the TORSION SPRING.
NOTE9a:
During the procedure, be careful not to break, deform,
or lose any parts.
(3) Remove the two SPECIAL SCREWS (1 and 2), and then
remove the BASE (BARRIER).
(4) Remove the SLIDER.
(5) Remove the KNOB.
(6) Remove the BARRIER (A) and the ARM together as as-
sembled.
NOTE9b:
Removing the ARM from the BARRIER (A) at a wrong
angle could cause damage or deformation of the at-
tachment part.
(7) Remove the BARRIER (B).
DITAIL OF KNOB AND SLIDER
Attach the SLIDER by placing the KNOB hole
and the ARM BOSS parallel.
SLIDER
KNOB
Adjust the KNOB hole
and the SLIDER hole.
NOTE9a,e
TORSION SPRING
NOTE9e
Boss of ARM
NOTE9d
ARM
Place the ARM BOSS
into the SLIDER frame.
SLIDER
BASE(BARRIER)
1
(S9)
2
(S9)
TORSION
SPRING
Boss of
BASE(BARRIER)
Assembly procedure
(1) Attach the BARRIER (B).
NOTE9c:
Be careful with the attachment direction. Attach the
BARRIER (B) with its wrinkle side facing outside.
(2) With the ARM assembled, attach the BARRIER (A) by fit-
ting the ARM BOSS into the COVER ASSY hole.
(3) Attach the KNOB.
(4) Attach the SLIDER.
NOTE9d:
Attach the SLIDER by placing the KNOB hole and the
ARM BOSS parallel as shown in the figure.
(5) Attach the BASE (BARRIER), check if there is no uplift
or unevenness, and then tighten with the two screws (1
and 2).
(6) Attach the TORSION SPRING.
NOTE9e:
After the attachment, move the KNOB to check the
smooth operation of the two BARRIERS (A and B)
(7) Attach the COVER (MIC).
NOTE9e
KNOB
NOTE9c,e
BARRIER(B)
ARM
BOSS
NOTE9b
BARRIER(A)
NOTE9c,e
COVER(MIC)
Fig.3-2-18
L9b
L9a
(No.YF180)1-13
L9c
Advertisement
