Table of Contents
Advertisement
U
I
S
2.12
Electrical connections
Make electrical connections according to the requirements
set out in sections General Warnings and Fundamental
Safety Rules by reference to the patterns present in the
installation and accessories manuals.
Before doing any work, make sure the power is switched
off.
2.13
Maintenance
Routine maintenance is indispensable to keep the heat
pump convector in perfect working condition, safe and
reliable over the years. This can be done every six months
2.14
Cleaning the outside
Before every cleaning and maintenance intervention,
disconnect the appliance from the mains by switching
off the master switch.
Wait until the parts have cooled down to avoid the risk
of burns.
The unit must be connected to the mains through a
multipolar switch with minimum contact opening of at
least 3mm or with a device that allows the complete
disconnection from the device under the overvoltage
conditions category III.
for some interventions and annually for others, by the
Technical Service Assistance, technically authorised and
prepared, using always original spare parts.
Do not use abrasive sponges or abrasive or corrosive
detergents to avoid damaging the painted surfaces.
When necessary, clean the outer surfaces of the heat
pump convector with a soft damp cloth.
INSTALLATION
EN
13
Advertisement
Table of Contents
