This command will open the CAN interface utility. To start the CAN utility in the future, follow Steps 4 and 5 only.
8.2 Setting the Baud Rate
Using the CAN interface utility software, the baud rate for each port can be selected. On the desired CAN port,
select the baud rate from the Baud Rate drop-down menu. After selecting the desired baud rate, press "Connect"
to connect with specified baud rate as shown in below figure.
To change the baud rate, click on "Disconnect" and select a new baud rate.
www.diamondsystems.com
DS-MPE-CAN2L User Manual Rev A.1
Page 11