Table of Contents
Advertisement
7. JUMPER CONFIGURATION
The DS-MPE-CAN2L module has two line termination jumper blocks, one for each port. Jumper block J3 is for
port J4, and jumper block J6 is for port J7. Jumper blocks J3 and J6 are identical. The default is no jumpers
installed. To add termination for a port's bias line (jumper position B), CAN-H line (jumper position H), or CAN-L
line (jumper position L), add a jumper at B, H or L location respectively.
DS-MPE-CAN2L User Manual Rev A.1
B
H
L
O
O
O
O
O
O
www.diamondsystems.com
Page 9
Advertisement
Table of Contents
