Table of Contents
Advertisement
DMX4.5
DMX10
Master/Slave Fixture Linking
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
Often, the setup for Master-Slave
and Standalone operation requires
that the first fixture in the chain be
initialized for this purpose via
settings in the control panel.
Secondarily, the fixtures that follow
may also require a slave setting.
Please consult the "Operating
Instructions" section in this manual
for complete instructions for this
type of setup and configuration.
Mounting
O RI E NT AT IO N
This fixture may be mounted in any safe position.
RIG G ING
Mount the fixture using, a suitable "C" or "O" type clamp.
Adjust the angle of the fixture by loosening both knobs
tilting the fixture. After finding the desired position, retighten both
knobs.
When selecting installation location, take into consideration fuse
replacement and routine maintenance.
2 clamps must be used with this fixture.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain,
high humidity, extreme temperature changes or restricted ventilation.
COLORstrip™ Mini User Manual
DMX Cable 4.5m/14.8ft
DMX Cable 10m/32.8ft
Slave
10
Slave
Master
Hanging Clamp
Note!
Clamp is sold separately.
1/26/2010 2:49 PM
and
Advertisement
Table of Contents
