Gigabyte GA-M52L-S3P User Manual page 71

After that, the Array List screen appears, displaying the RAID array that you have created (Figure 7).
[Ctrl-X] Exit
To read more information about the RAID array, press <Enter> to enter the Array Detail screen (Figure
8), which shows various information about the array, including the RAID mode, stripe block size, hard
drive model name, and hard drive capacity, etc.
RAID Mode: Striping
Striping Width : 2
Port
1.0
1.1
To delete the array, press <D> in the Array Detail screen. When the "Delete this array?" message
appears, press <Y> to confirm or <N> to cancel. Press <Enter> to return to the Array List screen.
To exit the NVIDIA RAID setup utility, press <Esc> in the main menu or <Ctrl>+<X> in the Array List
screen.
Now, you can proceed to the installation of the SATA controller driver and operating system.
MediaShield Utility Nov 20 2006
Boot Status
No Healthy
  ] Select 
[
Array 2: NVIDIA STRIPE 233.57G
Index Disk Model
0 ST3120026AS
1 ST3120026AS
[R] Rebuild [D] Delete
- Array List -
Vendor Array Model Name
NVIDIA STRIPE 223.57G
[B] Set Boot [N] New Array
Figure 7
- Array Detail -
Striping Block: 64K
[C] Clear Disk
Figure 8
- 71 -
[ENTER] Detail
Capacity
111.79GB
111.79GB
[ENTER] Return
Appendix