Gigabyte GA-M52L-S3P User Manual page 70

Step 5:
Next, select the hard drives which you wish to be included in the disk array. The Free Disks block
displays the information about the SATA hard drives that are available for use as RAID array drives.
Press <Tab> to move to the Free Disks block. Select the target hard drives using the up or down arrow
key and use the right arrow key to add the hard drives to the Array Disks block (Figure 5).
RAID Mode: Striping
Free Disks
Port Disk Model
[ESC] Quit
Step 6:
After assigning the RAID drives, press <F7>. A message which says "Clear disk data?" appears
(Figure 6). Press <Y> to confirm or press <N> to cancel. (If the hard drives contain a previously created
RAID array, you need to press <Y> to clear the data in the hard drives.)
RAID Mode: Striping
Free Disks
Port Disk Model
[ESC] Quit
GA-M52L-S3P Motherboard
MediaShield Utility Nov 20 2006
- Define a New Array -
Capacity
[F6] Back [F7] Finish
MediaShield Utility Nov 20 2006
- Define a New Array -
Clear disk data?
Capacity
[Y] YES
[Y] YES
[F6] Back [F7] Finish
Striping Block:
Array Disks
Port Disk Model
1.0 ST3120026AS
[     ] Add
1.1 ST3120026AS
[     ] Del
[TAB] Navigate [
Figure 5
Striping Block:
Array Disks
Port Disk Model
[N] NO
Clear disk data ?
1.0.M ST3120026AS
[     ] Add
1.1.M ST3120026AS
[N] NO
[     ] Del
[TAB] Navigate [
Figure 6
- 70 -
Optimal
Capacity
111.79GB
111.79GB
 ] Select 

[ENTER] Popup
Optimal
Capacity
111.79GB
111.79GB
 
] Select 
[ENTER] Popup