Connecting The Drain Line - LG FH069FDFS Owner's Manual

16
INSTALLATION INSTRUCTIONS

Connecting the drain line

Secure the drain hose in place to prevent
moving and leaking.
NOTE
• The drain hose should be properly secured.
Failure to properly secure the drain hose
can result in flooding and malfunction.
• Total height of the hose end should not
exceed 39,4 inches (100,0cm) from the
bottom of the washer.
• The drain must be installed in accordance
with any applicable local codes and regula-
tions.
• Make sure that the water lines are not
stretched, pinched, crushed, or kinked.
Using a standpipe
1
Clip the end of the hose into the elbow
bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose.
If the drain hose is extended more than
4 inches (10 cm) beyond the end of the
elbow bracket, mold or microorganisms
could spread to the inside of the washer.
No more than
4 inches (10 cm)
Elbow Bracket
2
Insert the end of the drain hose into the
standpipe.
3
Use a tie strap to secure the drain hose in
place.
Elbow Bracket
Drain Hose
Using a laundry tub
1
Clip the end of the hose into the elbow
bracket.
- Connect the elbow bracket within 4 inches
(10 cm) from the end of the drain hose.
If the drain hose is extended more than
4 inches (10 cm) beyond the end of the
elbow bracket, mold, or microorganisms
could spread to the inside of the washer.
No more than
4 inches (10 cm)
2
Hang the end of the drain hose over the side
of the laundry tub.
3
Use a tie strap to secure the drain hose in
place.
Connecting the auto dosing
1
Unscrew the 2 screws on the protective
cover and remove the cover.
2 onnect the auto dosing harness from
C
ccessory parts.
A
NOTE
• The voltage of the auto dosing machine
should be the same as the washer's voltage.
Elbow Bracket
Elbow
Bracket
Laundry Tub
max. 39,4"
(1,0 m)
max. 39,4"
(1,0 m)
Drain Hose
Tie Strap