DeWalt DCS387P1 Instruction Manual page 13

75–100% charged
51–74% charged
< 50% charged
Pack needs to be charged
To actuate the fuel gauge, press and
hold the fuel gauge button (H). A
combination of the three green LED
lights will illuminate designating the level
of charge left. When the level of charge
in the battery is below the usable limit,
the fuel gauge will not illuminate and the
battery will need to be recharged.
NOTE: The fuel gauge is only an
indication of the charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based on product
components, temperature and end-user application.
For more information regarding fuel gauge battery packs, please
contact call 1-800-4-D WALT (1-800-433-9258) or visit our website
e
www.dewalt.com.
Blade Installation and Removal
(Fig. 5–7)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Different blade lengths are available. Use the appropriate blade for
the application. The blade should be longer than 3-1/2" (89 mm)
and should extend past the shoe and the thickness of the workpiece
during the cut. Do not use jigsaw blades with this tool.
does not extend past the shoe and the workpiece during the cut
(Fig. 5). Increased risk of personal injury, as well as damage to the
shoe and workpiece may result.
FIG. 4A
H
TO INSTALL BLADE INTO SAW
1. Pull blade clamp release lever (C) up
2. Insert blade shank from the front.
3. Push blade clamp release lever down.
NOTE: The blade can be installed in four
positions as shown in Figure 7.
11
WARNING: Cut hazard. Blade breakage may occur if the blade
FIG. 5
(Fig. 6).
FIG. 6
C