Table of Contents
Advertisement
5) IDE1/ IDE2 [IDE1 / IDE2 Connector(Primary/Secondary)]
IDE2
IDE1
6) FDD (Floppy Connector)
1
7) PWR_LED
1
MPD+
MPD-
MPD-
Ø Important Notice:
1
Please connect first harddisk to IDE1
and connect CDROM to IDE2.
1
Ø Please connect the floppy drive ribbon cables
to FDD. It supports 360K,720K, 1.2M, 1.44M
and 2.88M bytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.
Ø PWR_LED is connect with the system power
indicator to indicate whether the system is
on/off. It will blink when the system enters
suspend mode.
If you use dual color LED, power LED will turn
to another color.
- 17 -
Hardw are Installation Process
Advertisement
Table of Contents
