Table of Contents
Advertisement
9) 2X_DET
When an AGP 2X (3.3V) card is installed the 2X_DET w ill light up, indi c ating a nonsupported graphics
card is inserted. Informi n g users that sy stem might not boot up normally due to AGP 2X (3.3V) is not
supported by the chipset.
10) F_PANEL (2x10 pins connector)
Please connect the pow er LED, PC peaker, reset sw itch and pow er sw itch etc of y our chassis front
panel to the F_PANEL connector according to the pin assignment abov e.
HD (IDE Hard Disk Active LED)
(Blue)
SPK (Speaker Connector)
(Amber)
RES (Reset Switch)
(Green)
PW (Soft Power Connector)
(Red)
MSG(Message LED/Power/
Sleep LED)(Yellow)
NC( Purple)
-
+
Speaker
Connector
SPK-
SPK+
Soft Power
PW-
Connector
PW+
MSG-
MSG+
Me ssa ge LE D/P owe r/
Sleep LED
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Open: Normal Operation
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC
- 25 -
20
19
Reset Switch
1
NC
1
RES+
RES-
1
HD-
1
1
HD+
2
1
IDE Hard Disk
Active LED
Hardw are Installation Process
Advertisement
Table of Contents
