LG DLGX9001V.ASSEEUS Owner's Manual page 48

48
TrOuBLEShOOTiNg
Before Calling for Service (cont.)
Problem
Steam does not • Water level error.
generate but
no error code is
shown
Garments still • Too many or too different types
wrinkled after of garments in dryer.
STEAM FRESH™
There are no • The function of this cycle is to
creases left on remove wrinkles from fabric.
garment after
STEAM FRESH™
Water drips from • This is normal.
door during
Steam Cycle
Steam is not • This is normal.
visible during
Steam Cycle
Drum does not • This is normal.
turn during
Steam Cycle
Cannot see • This is normal.
steam vapor at
the beginning of
cycle
The display • MORE TIME button pressed.
shows
Odors remain • STEAM FRESH™ did not remove
in clothing after odor completely.
STEAM FRESH™
CHECK FILTER • Lint filter is almost clogged or
light is on during full.
the drying cycle
TM
FLOW SENSE • Ductwork is too long or has too
many turns/restrictions.
indicator shows
four bars during
• Significant blockage of the
the drying cycle
ductwork due to lint buildup or
or the display
debris.
shows "d80" after
• The appliance has detected a
drying.
restriction in the external dryer
venting.
Possible Causes
• Unplug dryer and call for service.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
• Use an iron to make creases.
• Condensation will normally form on the inside of the
dryer door during steam operation. Some condensation
may drip out the bottom of the door.
• Steam vapor is difficult to see when the door is closed.
However, condensation will normally form on the
inside of the dryer door if the steam system is operating
normally.
• The drum is turned off so that the steam vapor remains
in the drum. The drum will normally turn for about 2
seconds once a minute.
• Steam is released at different stages of the cycle for each
option.
• This display indicates that the steam option has been set
for a " " item such as a comforter.
Press the LESS TIME button to reduce the indicated load
size.
• Fabrics containing strong odors should be washed in a
normal cycle.
• Pause the drying cycle and clean the lint filter.
• Install a shorter or straighter duct run. See the Installation
Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may
be longer.
• If exhaust restrictions are sensed by the Flow Sense
system, the indicator will remain on for two hours after
the end of the cycle. Opening the door or pressing the
Power button will turn off the display.
Solutions
TM