Gigabyte GA-7VM400AM User Manual page 93

5. Use the arrow key to highlight Start Create Process and press <Enter>. A warning message
will appear, Press Y to finish the creation, or press N to cancel the creation.
6. Important note: All existing content in the hard drive will be destroyed after array creation.
B-2 Delete Disk Array
A RAID can be deleted after it has been created. To delete a RAID, use the following steps:
1. Select Delete Array in the main menu and press <Enter>. The channel column will be
activated.
2. Select the member of an array that is to be deleted and press <Enter>. A warning message will
show up, press Y to delete or press N to cancel.
VIA Technologies,Inc. VIA VT8237 Serial ATA BIOS Setting Utility V1.20
uAuto Setup For Performance
uArray Mode RAID 0 (Striping)
uSelect Disk Drives
uBlock Size 64K
uStart Create Process
The select array will be destoried.
Are you sure? Continue ?Press Y/N
Channel
[*]Serial_Ch0 Master
[*]Serial_Ch1 Master
Deleting a disk array will destroy all the data on the disk array except RAID 1 arrays. When a RAID is
deleted, the data on these two hard disk drives will be reserved and become two normal disk drives.
B-3 Select Boot Array
User can select a disk array as boot device if user wants to boot operating system from an array.
Boot disk array cannot be selected if the operating system does not boot from the disk array. Highlight
the Select Boot Array item; press <Enter> and the channel column will be activated. Then highlight the
target disk array and press <Enter>. If user selects a disk array that has a boot mark and press <Enter>,
its boot setting will be canceled.
Delete a RAID array contain the hard disks
attached to VIA IDE controller
F1
h i
,
Enter
ESC
Driver Name Array Name
ST380013AS ARRAY0
ST9120023AS ARRAY0
- 89 -
: View Array/disk Status
: Move to next item
: Confirm the selection
: Exit
Mode Size(GB) Status
SATA 74.53 Stripe0
SATA 111.79 Stripe1
Technical Reference