Gigabyte GA-7VM400AM User Manual page 91

B-1Create Disk Array
1. Use the arrow keys to navigate the main menu. Use the up and down arrow keys to select the
Create Array command and press <Enter> to call out the list of creation steps.
VIA Technologies,Inc. VIA VT8237 Serial ATA BIOS Setting Utility V1.20
uAuto Setup For Data Security
uArray Mode RAID 0 (Striping)
uSelect Disk Drives
uStart Create Process
Channel
Serial_Ch0 Master
Serial_Ch1 Master
2. Select Array Mode and press <Enter>, a list of array modes will appear. Highlight the target
array mode that you want to create, and press <Enter> to confirm the selection. If RAID 1 is
selected, an option list will popup and enable the users to select Create only or Create and
duplicate. Create only will allow BIOS to only create an array. The data on the mirroring
drive may be different from the source drive. Create and duplicate lets BIOS copy the data
from the source to the mirroring drive.
VIA Technologies,Inc. VIA VT8237 Serial ATA BIOS Setting Utility V1.20
uAuto Setup For Data Security
RAID 0 for performance
uArray Mode RAID 0 (Striping)
RAID 1 for data protection
uSelect Disk Drives
RAID 0/1
uStart Create Process
RAID SPAN for capacity
Channel
Serial_Ch0 Master
Serial_Ch1 Master
Create a RAID array with the hard disks attached
to VIA IDE controller
F1
h i
,
Enter
ESC
Driver Name Array Name
ST380013AS
ST9120023AS
Create a RAID array with the hard disks attached
to VIA IDE controller
F1
h i
,
Enter
ESC
Driver Name Array Name
ST380013AS
ST9120023AS
- 87 -
: View Array/disk Status
: Move to next item
: Confirm the selection
: Exit
Mode Size(GB) Status
SATA 74.53 Hdd
SATA 111.79 Hdd
: View Array/disk Status
: Move to next item
: Confirm the selection
: Exit
Mode Size(GB) Status
SATA 74.53 Hdd
SATA 111.79 Hdd
Technical Reference