Connecting The Assembly Cable - Samsung AS05T Series User & Installation Manual

Connecting the assembly cable

Model
AS05/07/09/12**
AS18**
AS24**
AQ09/12**
3G, 1.0 mm H05VV-F
AQ18**
3G, 1.5 mm H05VV-F
• Connect the power cable to the auxiliary circuit breaker. If every pole fails to connect to
the power supply, it must be incorporated in a wire with a contact opening of ≥3mm.
Connecting the cable
Electrical work
1) For electrical and earth works, comply with the 'technical standards of electrical installations' and the
the 'wiring regulations' of the Electricity Enterprises Act.
2) Tighten the terminal block screw to under 12kgf.cm.
3) Precautions when connecting terminal blocks of the indoor unit
Before connecting, make sure the connecting part of the terminal socket is facing upwards.

There must be no space between the terminal and the screw when connected.

• For the terminal block wiring, use a wire with a ring terminal socket only.
CAUTION
The outdoor unit is powered from the indoor unit through the assembly cable.
If the outdoor unit is more than 5 meters away from the indoor unit, you must
extend the cable. The maximum length of the cable is 15 (**05/07/09/12/18**) /20 (**24**)meters.
1
Extend the assembly cable if necessary.
2
Open the front grille.
3
Remove the screw securing the connector cover.
4
Pass the assembly cable through the rear of the indoor unit and connect the
assembly cable to terminals as seen in the picture.
• Each wire is labeled with the corresponding terminal number.
5
Pass the other end of the cable through the 65mm hole in the wall.
6
Close the connector cover, tightening the screw carefully.
7
Close the front grille.
8
Remove the terminal board cover on the side of the outdoor unit.
Power cable Interconnection cable
3G, 1.0mm
2 3G, 1.0mm
3G, 1.5mm
2
3G, 1.5mm
3G, 2.5mm 3G, 2.5mm
2
5G, 1.0 mm H07RN-F
5G, 1.5 mm H07RN-F
The terminal socket
Upside down
is damaged.
The terminal socket
is upside down.
2
2
2
There is no ring terminal
to cover the wire.
or there is a space between the screw
and the ring terminal.
ng work.
27