Table of Contents
Advertisement
Phase: Synchronize the signal timing of the display with the graphic card. If the
image appears to be unstable or flickers, use the Phase to correct it. This is a fine
adjustment.
Note:
The Phase can be adjusted only in VGA mode.
Display
The Display menu allows you to modify the display settings, such as keystone,
projection, auto focus, and manual focus.
Auto Keystone: Select On to automatically adjust image distortion caused by tilting
the projector.
Note:
The Auto Keystone function can be only used to adjust the image distortion vertically.
Keystone: Adjust image distortion caused by tilting the projector (+/-40 degrees).
Note:
If you adjust the keystone degree manually then the Auto Keystone function will be
automatically switched off.
Projection: Select the projection mode, depending upon how the projector is
mounted.
Auto Keystone: On
y
Auto Keystone: Off
y
26 English
Auto Keystone
Keystone
Projection
Auto Focus
Manual Focus
Select
No reverse
Left/ Right reverse
No reverse
Left/ Right reverse
Up/ Down reverse
Up/ Down and Left/ Right reverse
Display
On
On
Exit
Enter
Advertisement
Table of Contents
