Troubleshooting - Cub Cadet 21AB455C710 Operator's Manual

Idler Pulley Rod
Belt Keeper
Bracket
Engine Pulley
Figure 7-2
Off-Season Storage
If the tiller will not be used for a period longer than 30 days, the
following steps should be taken to prepare the tiller for storage.
Trouble Possible Cause(s)
Engine fails to start Fuel tank empty, or stale fuel.
Throttle control lever not in correct
starting position (if so equipped).
Blocked fuel line.
Dirty air cleaner.
Choke not in ON position.
Spark plug wire disconnected.
Faulty spark plug.
Engine flooded.
Engine runs erratic Unit running on CHOKE.
Spark plug wire loose.
Blocked fuel line or stale fuel.
Vent in gas cap plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Carburetor out of adjustment.
Engine overheats Engine oil level low.
Dirty air cleaner.
Air flow restricted.
Carburetor not adjusted properly.
Tines do not Foreign object lodged in tines.
engage Tine clevis pin(s) missing.
Pulley and idler not in correct
adjustment.
Not shifting properly.
Control cable not adjusted properly.
Belt worn and/or stretched.
Tines skip over Improper rotation.
ground
Wheels do not Clevis pin missing.
engage Tiller is not being shifted properly.
Control cable not adjusted properly.
Belt worn and/or stretched.
• Clean the exterior of engine and the entire tiller
thoroughly. Lubricate the tiller as described in the
lubrication instructions.
• We do not recommend the use of pressure washers
to clean your unit. They may cause damage to
electric components, spindles, pulleys, bearings or
the engine. The use of pressure washers will result
in shortened life and reduce serviceability.
• Refer to the engine manual for correct engine
storage instructions.
• Wipe tines with oiled rag to prevent rust.
Idler Bracket
• Store tiller in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in an
unventilated or metal storage shed, care should be taken
to rustproof the equipment. Using a light oil or silicone, coat
the equipment and especially any springs, bearings, and
cables.
Corrective Action
Fill tank with clean, fresh gasoline. Fuel will not last
over thirty days unless a fuel stabilizer is used.
Move throttle lever to start position.
Clean fuel line.
Refer to the engine manual packed with your unit.
Move switch to ON position.
Connect wire to spark plug.
Clean, adjust gap or replace.
Refer to the engine manual packed with your unit.
Move choke lever to OFF position.
Connect and tighten spark plug wire.
Clean fuel line; fill tank with clean, fresh gasoline. Fuel will
not last over thirty days unless a fuel stabilizer is used.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Fill crankcase with proper oil.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Adjust carburetor as instructed in separate engine manual.
Dislodge foreign object.
Replace tine clevis pin(s).
Take unit to authorized service dealer.
Refer to Controls section of operator's manual for
proper shifting procedures.
Adjust control cable (see assembly instructions).
Replace belt.
Forward rotation should only be used on soil that has
already been tilled, not on virgin soil.
Replace clevis pin.
Refer to Controls section of operator's manual for
proper shifting procedures.
Adjust control cable (see assembly instructions).
Replace belt.
13
8
Trouble
Shooting
Guide
WARNING
Do not move the gear
selection handle
with the wheels or
tines engaged. Make
certain the unit is
stopped completely
before changing the
gear selection. A
partial engagement
may be necessary
when engaging tines.
Do not push down
on the handles so
that the wheels are
lifted off the ground
while using the tine
drive, or the tiller
could move backward
and cause personal
injury.
Never attempt to
make any adjust-
ments while the
engine is running,
except where speci-
fied in operator's
manual.