Descaling procedure
The descaling procedure lasts 30 minutes and consists of a descaling cycle
and a rinsing cycle. When the orange descaling light lights up continuously,
you need to descale the machine.
Note: Do not remove the brewing unit during the descaling procedure.
Preparation
1
Switch off the machine.
If you do not switch off the machine, you cannot enter the descaling cycle.
2
Empty the drip tray and place it back.
3
Empty the water tank and remove the Intenza+ water filter
(if present). Pour the entire bottle of descaling solution into the
water tank.
4
Add water to the descaling solution in the water tank up to the
MAX indication.
5
Place a bowl under the coffee spout.
Descaling cycle
1
Press the coffee button for approximately 5 seconds.
The orange descaling light flashes slowly during the entire descaling
,
cycle.
After each interval of one minute, the descaling solution flows out of
,
the coffee spout. This happens several times until the water tank is
completely empty.
5 sec
Note: If you want to interrupt the flow of the descaling solution press the
coffee button.To restart the flow of the descaling solution, press the coffee
button again.
ENGLISH
19