Toshiba PP350 User Manual page 137

This procedure does not affect the settings.
Use hot keys.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons: Built-in HDD,
CD-ROM, FDD, Network (LAN), PCA (ATA) card boot.
NOTE: A bar will appear only under the selected device.
3. Use the left/right cursor keys to highlight the boot device you want and press
Enter.
NOTES: 1. If a supervisor password is set, the menu above does not
appear when you use the user password to start the
computer.
2. The selection method above does not change the boot
priority settings in HW Setup.
3. If you press a key other than one of those above or if the
selected device is not installed, the system will boot according
to the current setting in HW Setup.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]
[RPL]
NOTES: 1. PC card HDD boot is supported only by the PC card slot
on the computer. Support is guaranteed only for TOSHIBA
PC card HDDs.
Sets PXE as the protocol. (Default)
Sets RPL as the protocol.
HW Setup
7-7