Toshiba PP350 User Manual page 103

Hibernation: When you press Fn + F4, the computer can enter Hibernation. To
avoid entering Hibernation unexpectedly, a dialog box appears for verification.
However, if you check the checkbox in the dialog box, it will not appear from the
next time.
Display selection: Press Fn + F5 to change the active display device. When
you press these hot keys a dialog box appears. Only selectable devices will be
displayed. Hold down Fn and press F5 again to change the device. When you
release Fn and F5, the selected device will change. If you hold down the keys for
three seconds the selection will return to LCD.
LCD Display Brightness: Pressing Fn + F6 decreases the LCD display bright-
ness in increments. When you press these hotkeys, the current setting will be
displayed for two seconds by a pop-up icon. You can also change this setting
through the Monitor brightness item of the Power Save Mode window in Power
Saver.
LCD Display Brightness: Pressing Fn + F7 increases the LCD display bright-
ness in increments. When you press these hotkeys, the current setting will be
displayed for two seconds by a pop-up icon. You can also change this setting
through the Monitor brightness item of the Power Save Mode window in Power
Saver.
NOTE: You cannot change the display brightness for about 18 seconds
after the LCD turns on. To protect display quality, the brightness level is
set at the maximum value.
Soft keys: Fn key combinations
5-5