Table of Contents
Advertisement
not be displayed under some operating or environmental conditions.
Battery capacity decreases over time and through repeated use. If decreased usage time
between charges becomes significant, it is probably time to replace it with a new one.
[277] Troubleshooting
The charge lamp on the product flashes when charging
the battery pack.
Make sure that the battery is NP-FW50.
Remove the battery pack and then reinsert it into the product.
Batteries which have not been used for more than a year may have deteriorated.
Charging has paused temporarily because the camera is not within the appropriate
temperature range.
This phenomenon occurs when you charge the battery pack in an extremely hot or cold
location. The optimum temperature for charging the battery pack is between 10 °C and 30
°C (50 °F and 86 °F).
[278] Troubleshooting
The battery pack is not charged.
When the battery pack is not charged (the charge lamp does not light) even if you follow
the proper charging procedure, check if the power of the product is turned off, then
remove the battery pack and re-insert the same battery pack securely, or disconnect and
reconnect the USB cable.
[279] Troubleshooting
The monitor does not turn on even when the product is
turned on.
[FINDER/MONITOR] has been set to [Viewfinder(Manual)]. Change [FINDER/MONITOR]
to [Auto].
Troubleshooting
Troubleshooting
Troubleshooting
Battery pack and power
Battery pack and power
Battery pack and power
Advertisement
Table of Contents
