Connecting The Water Supply Hose - LG F4V308 N Series Owner's Manual

EN 16 INSTALLATION
NOTE
• The appliance must be 100%
horizontal and stand firmly in position
on a hard flat floor.
• It must not 'Seesaw' across corners
under the load.
• Do not let the feet of the appliance get
wet. Failure to do so may cause
vibration or noise.
Using Anti-Slip Sheets
This feature may vary depending on the
model purchased.
If you install the appliance on a slippery
surface, it may move because of
excessive vibration. Incorrect levelling
may cause malfunction through noise
and vibration. If this occurs, install the
anti-slip sheets under the levelling feet
and adjust the level.
1
Clean the floor to attach the anti-slip
sheets.
• Use a dry rag to remove and clean
foreign objects and moisture. If
moisture remains, the anti-slip
sheets may slip.
2
Adjust the level after placing the
appliance in the installation area.
3
Place the adhesive side
slip sheets on the floor.
• The most effective way is to install
the anti-slip sheets under the front
feet. If it is difficult to place the
sheets under the front feet of the
4
NOTE
• Additional anti-slip sheets are available
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between 50
• Periodically check the condition of the
of the anti-
a
NOTE
• Do not overtighten the water supply
appliance, attach them under the
rear feet.
Put the appliance on the anti-slip
sheets.
• Do not attach the adhesive side
of anti-slip sheets to the feet of the
appliance.
at LG Electronics service centre.
kPa and 800 kPa (0.5‒8.0 kgf/cm²). If
the water pressure is more than 800
kPa, a decompression device should
be installed.
water supply hose and replace the
water supply hose if necessary.
hose or use mechanical devices to
tighten onto the inlet valves.
a