Table of Contents
Advertisement
1 2 3 4 5 6 7 8 9 10
Setting the speaker impedance
(U.S.A. and Canada models only)
Under its default settings, the unit is configured for 8-ohm speakers. When connecting
6-ohm speakers, set the speaker impedance to "6 Ω MIN".
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press z (power).
z (power)
STRAIGHT
3
Check that "SP IMP." is displayed on the front display.
CHARGE
ENHANCER STEREO TUNED
PARTY
SLEEP
ZONE
ZONE
2 A
3 B
OUT
1 2
ECO
SP IMP.••8¬MIN
4
Press STRAIGHT to select "6 Ω MIN".
5
Press z (power) to set the unit to standby mode and remove the
power cable from the AC wall outlet.
You are now ready to connect the speakers.
MUTE
VOL.
ADAPTIVE DRC
VIRTUAL
15
En
Advertisement
Table of Contents
