Whirlpool WED9620HW Installation Instructions Manual page 23

7.
Reinstall door on dryer
Using a T25 screwdriver, remove the 4 screws on the dryer.
®
Insert the tabs on the hinge into the mounting slot and slide
down to engage the top tab. Secure in place with the 4 screws
removed earlier.
Reverse door swing round-shaped door
with curved glass – double handle
1.
Remove door from dryer
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25 screwdriver, remove the 4 screws securing the
®
door hinge to the dryer and lift up and out to remove the door.
Place the door on a soft towel or other non-scratch surface.
Reinstall the 4 screws in the holes.
2.
Move the door strike
Using a T25 screwdriver, remove the 2 screws securing
®
the door strike to the door frame of the dryer. Rotate the
strike 180° and attach to the opposite side of dryer door
frame as shown.
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
23