Advertisement
2. Adjust the height difference between the doors
by turning the bolt ( 2 ) clockwise (
counter clockwise (
(3) Wrench
(2) Bolt
When you turn clockwise (
door will move up.
3. After adjusting the doors, turn the nut ( 1 )
clockwise (
end of the bolt, then tighten the bolt again with
the wrench ( 3 ) to fix the nut in place ( 1 ).
(3) Wrench
(2) Bolt
(1) Nut
If you do not secure the nut firmly, the bolt
may release.
DA68-02981J-00.indb 17
) or
).
), the
) until it reaches the lower
English - 17
MAKING MINOR ADJUSTMENTS
BETWEEN THE SHOW CASE AND
INNER CASE OF THE FRIDGE
After raising the out door, insert the supplied SHIM
HINGE MIDDLE in the gap between the Show
case of fridge and the HINGE-SHAFT.
The SHIM HING MIDDLE is included with
the refrigerator. The thickness of the SHIM
is 1 mm.
CAUTION
Don't make the Show Case door higer than Inner
Case door.
- The Show Case can break away from
STOPPER (HINGE )
14. 11. 25.
10:26
Advertisement
