Table of Contents
Advertisement
3)
Press as to select [Capture].
f Display the image you want to project at projector start-up.
4)
Press the <ENTER> button.
5)
A confirmation screen is displayed, press as to select [Yes] and then press the <ENTER> button.
f The captured image is registered as a user logo on this projector.
f After capturing the image, the [Logo select] is set to [User]. The user logo will be displayed when the projector starts up
next time.
Note
f Only supports still image-based computer (RGB) and still image-based HDMI signals input.
f Capture may not be available depending on the input signal.
f It is recommended to capture the same resolution signal as the display dots (panel resolution) of the projector.
For PT-LW375D, PT-LW335D : 1 280 x 800
For PT-LB425D, PT-LB425T, PT-LB385D, PT-LB385T, PT-LB355D, PT-LB355T and PT-LB305D : 1 024 x 768
f [Capture] cannot be set if [Logo PIN code lock] is set to [On].
f The correction state of the [Keystone] will be canceled temporarily when the image is being captured.
[Logo PIN code lock]
Prevent the logo from being changed by any person other than the administrator by setting a three-digit Logo PIN code.
1)
Press as to select [Logo].
2)
Press the <ENTER> button.
f The [Logo] screen is displayed.
3)
Press as to select [Logo PIN code lock].
4)
Press the <ENTER> button.
f The [Logo PIN code] input screen is displayed.
5)
Press the <ENTER> button.
6)
Enter the Logo PIN code you have set according to the steps in "Enter a Logo PIN code".
f To set the logo PIN code for the first time, you can enter the number (a three-digit number) you want to set according to
the steps in "Enter a Logo PIN code".
r Enter a Logo PIN code
i) Press as to select a number from 0 to 9.
ii) Press the <ENTER> button.
f The fixed number change to , the cursor move to the next digit.
iii) Repeat the above steps, and enter a three-digit number.
f Move the cursor to [Set] after fixing the three-digit number.
iv) Press the <ENTER> button.
f Return to the [Logo] screen.
7)
Press as to switch the item.
f The items will switch each time you press the button.
[On]
[Off]
Attention
f The initial Logo PIN code is "111".
f Change the Logo PIN code periodically that is hard to guess.
Note
f If you want to correct the digit, press the <MENU> button to reset the digit and then re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to return the menu screen.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
Chapter 4 Settings - [Expand] menu
Select this item to disable setting or changing of [Logo select] and [Capture].
Select this item to enable setting or changing of [Logo select] and [Capture]
ENGLISH - 67
Advertisement
Table of Contents
