Hoover Professional Series User Manual page 14

Notices
IMPORTANT
!
Regarding the Dirty Water Tank: For full suction it is
important that the Dirty Water Tank Lid is securely in
place. If misplaced, poor to no suction will result.
IMPORTANT
!
For full suction, it is important that the Dirty Water Tank
is properly secured before cleaning.
Continue using dry strokes until little water is visible
passing through the nozzle.
For best results, Hoover recommends rinsing carpet
with water only. This removes residual carpet cleaning
solution. Remove Solution Tank and repeat. For heavily
soiled areas, repeat. Avoid saturating carpet.
NOTE: Empty Dirty Water Tank when the motor sound
becomes higher pitched and there is a loss in suction
(see "Automatic shut-off"). You will also see the float
rise and shut off suction at the same time.
14
!
Do not clean over floor electrical outlets. Water will drip
from the brushes and underside of the product after use
and may puddle. To avoid damage to wood and laminate
flooring and to avoid potential slip hazard, after use (a)
do not leave the product on wood and laminate surfaces
and move to a hard surface and (b) place unit on an
absorbent material (such as a towel) to soak up drips.
!
CAUTION
! !