Stanley SXPW2621 Manual page 12

Hose to Pump (PIC. 5)
1. Attach the high pressure hose to the pump. Push hose
into pump and tighten nut. Ensure that the hose does
not touch the muffler or goes over the top of the fuel
tank.
2. Have hose lay to the back of the pump and curve to the
hose hanger.
Note: Do not allow high pressure hose to touch the muffler.
Damage will occur and will not be covered by warranty.
To remove hose, loosen nut and remove hose.
Pressure Hose to Gun Connection
Attach the high pressure hose to gun. Push hose into gun
and tighten nut.
To remove hose, loosen nut and remove hose.
Gun Safety Lock (PIC. 6)
To stop accidental use of the trigger, the gun is fitted with
a safety lock.
To lock;
Push lever down
To unlock;
Push lever up
Garden Connection (PIC. 7)
Screw black garden hose connection to pump
Dump Tube (PIC. 7)
During times of no water flowing whilst motor is running,
the pump will heat up. Periodically the pump will dump hot
water through the tube to cool down.
PIC. 5
PIC. 6
UP (UNLOCK)
DOWN
(LOCK)
PIC. 7
HOSE
CONNECTION
12
DUMP
TUBE