Table of Contents
Advertisement
with the remote control of the TV or other
HDMI-CEC devices.
•
[Sys Audio Control] (System audio
control): If system audio control is enabled,
the audio of the connected device is
output through your home theater
speakers automatically when you play the
device.
[Audio Mapping] (Audio input mapping):If
•
system audio control does not work, map
the connected device to the correct audio
input connector on your home theater.
(see 'Set up the audio' on page 11)
Note
•
To change the EasyLink control settings, press
(Home), select [Setup] > [Video] > [HDMI Setup] >
[EasyLink Setup] > [EasyLink].
Set up the audio
If you cannot hear the audio output of a
connected device through your home theater
speakers, do the following:
•
Check that you have enabled EasyLink
on all the devices, (see 'Set up EasyLink
(HDMI-CEC control)' on page 10) and
•
on your TV, set the audio output to
"Amplifier" (instead of TV speakers). For
details, see the TV user manual, and
•
setup the EasyLink audio control.
1
Press
(Home).
2
Select [Setup], and then press OK.
3
Select [Video], and then press OK.
4
Select [HDMI Setup] > [EasyLink Setup]
> [Sys Audio Control] > [On].
•
To play the audio from the TV
speakers, select [Off], and skip the
following steps.
5
Select [HDMI Setup] > [EasyLink Setup]
> [Audio Mapping].
6
Follow the onscreen instructions to map
the connected device to the audio inputs
on your home theater.
•
If you connect your home theater
to the TV through an HDMI ARC
connection, make sure that the TV
audio is mapped to the ARC input on
your home theater.
EN
11
Advertisement
Table of Contents
