Zanussi ZBB27650SV User Manual page 11

Problem
A or symbol is shown
instead of numbers on the
Temperature Display.
The lamp does not work.
The compressor operates con-
tinually.
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
"QuickFreeze" or "QuickChill",
or after changing the tempera-
ture.
Water flows on the rear plate
of the refrigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
Possible cause
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The "QuickFreeze" or
"QuickChill" is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost melts
on the rear plate.
Food products prevent the
water to flow into the water
collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Solution
Contact the nearest Authorised
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possible).
Close and open the door.
Contact the nearest Authorised
Service Centre.
Refer to "Operation".
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "QuickFreeze function"
or "QuickChill function".
Refer to "Closing the door".
The compressor starts after a pe-
riod of time.
This is correct.
Make sure that food products do
not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
11