Pioneer SPH-DA360DAB Operation Manual page 48

Menu Item
[Parking Assist Guide
Adjust]
[Rear View Camera
Adjustment]
Description
Adjusting the guidelines by dragging or touching /
1
/ / on the screen.
Touch [OK] to finish the settings.
2
TIP
Touch [Reset] to reset the settings.
CAUTION
• When adjusting the guidelines, be sure to park the vehicle in a
safe place and apply the handbrake.
• Before getting out of the car to place the markings, be sure to
turn the ignition switch off (ACC OFF).
• The range projected by the rear view camera is limited. Also, the
vehicle width and distance guidelines displayed on the rear view
camera image may differ from the actual vehicle width and
distance. (The guidelines are straight lines.)
• The image quality may deteriorate depending on the usage
environment, such as at night or in dark surroundings.
NOTES
• This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
• Using packing tape or similar tape place markings as shown
below before setting up the guidelines so that the guidelines can
be overlaid to the markings.
• Install the rear view camera as near the centre of the vehicle as
possible, and do not install it too low. Otherwise, the guideline
comes on the edge of the screen, preventing the guideline from
being adjusted.
2 m
Markings
Markings
Adjust following menu, touch [+]/[-] to adjust.
NOTE
This setting is available only when you stop your vehicle in a safe
place and apply the handbrake.
- 48 -
50 cm
25 cm
25 cm
Rear bumper
AX 2.7 m
M