Table of Contents
Advertisement
Making Copies
This section describes the basic procedure to perform standard copying.
1.
Check that printer is turned on.
2.
Load paper.
3. Press the COPY button.
The Copy standby screen is displayed.
4.
Load original document on platen or in ADF (Auto Document Feeder).
5. Confirm the page size (A) and magnification (B).
Note
• To change or confirm the page size, magnification, or other settings, press the MENU button, then
use the
Setting Items for Copying
• Press the COPY button to reset the magnification to 100%.
6. Use the
button to specify the number of copies.
7. Press the Start button.
The printer starts copying.
Remove the original on the platen or from the document output slot after copying is complete.
Important
• If you load the original on the platen, do not open the document cover or remove the original while
Scanning... is displayed on the screen.
• If you load the original in the ADF, do not move the original until copying is complete.
Note
• To cancel copying, press the Stop button.
• If you load the original on the platen, you can add the copying job while printing.
Adding the Copying Job (Reserve copy)
button to display the desired setting item.
277
Advertisement
Table of Contents
