[Projector Setup] Menu; [Status]; [Computer2 Select]; [Projector Id] - Panasonic PT-VX425N Operating Instructions Manual

[PROJECTOR SETUP] menu

On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub-menu.
Refer to "Navigating through the menu" (x page 56) for the operation of the menu screen.
fAfter selecting the item, press asqw to set.

[STATUS]

You can check the using status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
[RUNTIME]
*
1
[SERIAL NUMBER]
*1 The following conversion is required to calculate the rough estimate for lamp replacement.
A ×1 + B × 5/7
f A : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [NORMAL]
f B : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO]
*2 The model No. of the optional lamp unit is subject to change without prior notice.
Note
f If you attach a lamp unit used in a projector of a model different from the projector (PT-VW355N, PT-VX425N) to the
projector, or when the lamp unit used in the projector to a projector of a different model, the [RUNTIME] displayed in
[STATUS] may differ from the actual time.

[COMPUTER2 SELECT]

Set whether to use the <COMPUTER 2 IN/1 OUT> terminal.
1) Press as to select [COMPUTER2 SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[COMPUTER2 IN]

[COMPUTER1 OUT] Outputs the signal which have been input <COMPUTER 1 IN> terminal.
Note
f The [COMPUTER2 SELECT] will be unavailable when [COMPUTER2] is selected as input source.
Chapter 4 Settings - [PROJECTOR SETUP] menu
[NAME]
[FREQUENCY]
[PROJECTOR]
[LAMP (ET-LAV300* )]
2
[NORMAL]
[ECO]
[PROJECTOR]
Formula for lamp replacement time (rough estimate)
When input the computer signal.
Displays the name of input signal.
Displays the scanning frequency of input signal.
Displays the current usage time of projector.
Displays the model No. of the replacement lamp unit for this
projector.
Displays the lamp runtime when [LAMP POWER] is set to
[NORMAL] by actual time.
Displays the lamp runtime when [LAMP POWER] is set to [ECO]
by actual time.
Displays the serial number of the projector.
ENGLISH - 77