Usb Upgrade; Network Updates - Philips 50PFL5922 User Manual

USB upgrade

You can upgrade the software by using USB memory stick.
1
Connect your USB memory stick with the upgrade file to the USB
terminal on the side of your TV.
2
Press MENU and use
OK.
3
Use to select USB, then press OK.
4
Use to select the desired update file, then press OK.
5
Use to select Yes, then press OK.
•
Read the on-screen instructions and confirm that you want to
continue with the installation.
Software update is in progress. Please wait.
Do not remove the USB storage device or turn the TV off
while upgrade is in progress.
6
When the software upgrade is completed, press
standby mode, then remove the USB memory stick.
7
Unplug the AC power cord for a few seconds from AC outlet and plug
it again.
8
Press again to turn the unit on.
•
The TV starts up with the new software.
•
For further assistance, please contact call center.
to select Update software, then press
to set the unit into

Network updates

You can update the software by connecting the unit to the internet.
1
Press MENU and use
OK.
2
Use to select Network, then press OK.
3
Use to select Yes, then press OK.
•
This unit will then start checking for the latest FirmWare (software)
version.
4
Confirmation message will appear.
Use to select Yes, then press OK.
•
The unit will start downloading the latest FirmWare (software)
version.
•
The unit will start updating the FirmWare (software) version.
•
It may take a while to complete the updating.
5
When the software update is complete, press
goes to standby mode.
6
Unplug the AC power cord for a few seconds from AC outlet and plug
it again.
7
Press again to turn the unit on.
•
The TV starts up with the new software.
For further assistance, please contact call center.
Note(s)
•
Please do not unplug the AC power cord or Ethernet cable while executing the Network
updates.
•
All settings will remain the same even if you update the software version.
•
The version of net service will also be updated if newer version of net service is available when
updating the firmware.
•
When you start up the TV or a net service after executing the software update, a message may
appear on the screen prompting for software update again. In this case, please select Update
to start USB update or network update. For further assistance, please contact call center.
42
to select Update software, then press
to make sure the unit
Continued on next page.
.
English