Dukane 6530B User Manual page 8

Power management function
The projector has power management functions. To reduce power consumption, the power management functions (1
and 2) are factory preset as shown below. To control the projector from an external device via a LAN or serial cable
connection, use the on-screen menu to change the settings for 1 and 2.
1. STANDBY MODE (Factory preset: NORMAL)
To control the projector from an external device, select [NETWORK STANDBY] for [STANDBY MODE].
NOTE:
• When [NORMAL] is selected for [STANDBY MODE], the following terminals and functions will not work:
MONITOR OUT terminal, AUDIO OUT terminal, USB(PC) port, LAN functions, Mail Alert function, DDC/CI (Virtual Remote Tool).
Please refer to page 75 about details.
• When [NETWORK STANDBY] has been set for [STANDBY MODE] and the LAN has been in link-down condition for 3 minutes,
[STANDBY MODE] will transit into [NORMAL] automatically for the purpose to save the consumption power.
2. AUTO POWER OFF (Factory preset: 1 hour)
To control the projector from an external device, select [OFF] for [AUTO POWER OFF].
NOTE:
• When [1:00] is selected for [AUTO POWER OFF], you can enable the projector to automatically turn off in 60 minutes if there is
no signal received by any input or if no operation is performed.
Note: The Dukane models described in this document are manufactured
by NEC and use the same firmware, software programs, control code,
and accessory parts. The equivalent Dukane to NEC models are shown
in the following table.
DUKANE
6530B
6530WB
6533B
6533WB
NEC
NP-ME301X
NP-ME301W
NP-ME331X
NP-ME331W
DUKANE
6536B
6536WB
6540B
6540WB
vi
Important Information
NEC
NP-ME361X
NP-ME361W
NP-ME401X
NP-ME401W