Table of Contents
Advertisement
Installation
Attaching the Stand
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
1
Open the packaging. Be careful when using a sharp
object to open the packaging. The product may be
damaged.
Put your hands in the grooves on either side of the
top layer of styrofoam covering the product and
remove it.
Attach the stand to the back of the monitor, in the
direction of the arrow.
5
While pressing down with one hand on the lower
styrofoam layer, lift the stand's neck with the other
hand.
2
Use the screws on the stand to tightly fasten.
6
Attach the stand base to the neck, as shown in
the image. Make sure there is no gap between the
stand neck and base.
3
Attaching the COVER-REAR TOP to the stand neck,
as shown in the figure.
7
Attach the stand base to the stand neck, and then
fasten the two screws on the base to tightly fix it.
4
Turn the COVER-REAR TOP clockwise to attach it to
the rear cover.
8
The stand is now completely assembled.
19
Advertisement
Table of Contents
