Hardware Connection - Internet - TP-Link TL-PA4010 User Manual

TL-PA4010 AV600 Powerline Adapter
properly connected with a powerline adapter through an Ethernet (RJ45) cable.
Following are the steps to properly connect the powerline adapter to your computer:
1． Connect one end of the provided Ethernet (RJ45) cable to an Ethernet port of the powerline adapter.
2． Connect the other end of the Ethernet (RJ45) cable to your computer's LAN port.
3． Plug the powerline adapter into a wall socket.
4． Turn on your computer.
5． Check and confirm that the Power LED and Ethernet LED on the powerline adapter are ON.
The hardware connection mechanism is shown below:

Note:
Do not connect the powerline adapter to any extension lead, power strip, extension cord or surge
protector, as this may degrade the network performance.
2.4 Hardware Connection – Internet
This section describes how to connect the powerline adapter into your existing ADSL broadband
connection via ADSL Ethernet port. Follow the procedures described below to connect the powerline
adapter to your ADSL broadband connection:
1． Connect one end of the provided Ethernet (RJ45) cable to an Ethernet port of the powerline adapter.
2． Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL
6