BenQ V Series User Manual page 11

To Connect the DVI-D Cable
Connect the plug of the DVI-D cable (at the end
without the ferrite filter) to the monitor video socket.
Connect the other end of the cable (at the end with the
ferrite filter) to the computer video socket.
Tighten all finger screws to prevent the plugs from
accidently falling out during use.
If there is more than one video transmission method available to you, you might want to take the picture quality
of each video cable into consideration before making the connection.
- Better quality: DVI-D
- Good quality: D-Sub
The video cables included in your package and the socket illustrations on the right may vary depending on the
product supplied for your region.
3. Connect the power cable to the monitor.
Connect the power cord to the power adapter. Plug
one end of the power cord into the socket labelled
on the rear of the monitor. Do not connect the other
end to a power outlet just yet.
4. Connect-to and turn-on the power.
Plug the other end of the power cord into a power
outlet and turn it on.
Picture may differ from product supplied for your region.
Turn on the monitor by pressing the power button on
the monitor.
Turn on the computer too, and follow the instructions
in Getting the most from your BenQ monitor on page
13 to install the monitor software.
To extend the service life of the product, we recommend
that you use your computer's power management function.
Or
2
1
How to assemble your monitor hardware 11